【答案解析】
5. Theft Deterrent SysTEM
1. Y该句句意为:根据说明，该系统是用来防止车辆被偷的。本题解题依据为文章第一段第一句话，与原文之义相符。
2. Y该句句意为:设定该防盗系统时，你应该让所有乘客下车。 本题依据为SETTING THE SYSTEM 标题下列出的第二点，与原文之义吻合。
3. N该句句意为: 当用钥匙打开车后门时，该系统设置将被取消。本题解题依据为CANCELLING THE SYSTEM 下面一段，该段大意为:用钥匙打开前门或滑门时，该系统将完全取消，显然本题句意与原文所述不符。
4. N该句句意为:该系统只有在使用钥匙打开前门、滑门、后门及发动机罩时才会起动。本题解题依据为Reactivating the system 下面第二句话即:If any of the front, sliding and back doors and hood is unlocked without using the key（如不用钥匙打开前门、滑门、后门和发动机罩，该系统将发出警报并切断系统电路），由此可见,该句意与本题之义相反。
5. N该句句意为: 如果终止警报，你得把车的点火钥匙从“ACC”位置拨到“LOCK”位置。本题解题依据为Stopping the alarm 下面第一句话:Turn the ignition key from the “LOCK”to “ACC”position （把点火钥匙从“LOCK”拨到 “ACC”位置），显然与原文不符。
6. N该句句意为: 当指示灯闪烁时，不需要用钥匙打开任何门和发动机罩。本题解题依据为INDICATOR LIGHT 下面的第二句话:You need the key to open the front, sliding and back doors and hood. （你需要钥匙打开前后门、滑门和发动机罩）。显然本题句意与原文所述不符。
7. NG该句句意为: 本文告诉我们该系统能有效工作以致从未出现故障。通览全文，本文根本未提及该信息。因而无法得知。
8.30 seconds答案依据为本文SETTING THE SYSTEM标题下“……the system will give you a preparation time of 30 seconds before the setting……”。
9.starts flashing答案依据为SETTING THE SYSTEM标题下，小标题4后面的内容。
10.Toyota Dealer答案依据为文章最后一句话。
www.qidian55.com Directions: In this part, you will have 15 minutes to go over the passage quickly
For questions 1-7, mark
Y （for YES）if the staTEMent agrees with the information given in the passage;
N （for NO）if he statement contradicts the information given in the passage;
NG （for NOT GIVEN）if the information is not given in the passage;
For questions 8-10, complete the sentences with the information given in the passage.
Theft Deterrent System
To deter the vehicle theft, the system is designed to give an alarm and keep the engine from being started if any of the front, sliding and back doors and hood is forcibly unlocked or the battery terminal is disconnected and then reconnected when the vehicle is locked.
The alarm blows the horn intermittently and flashes the headlights, tail lights and other exterior lights. The engine cannot be started because the starter circuit will be cut.
SETTING THE SYSTEM
1. Turn the ignition key to the “LOCK”position and remove it.
2. Have all passengers get out of the vehicle.
3. Close and lock the front, sliding and back doors and hood.
The indicator light will come on when the front, sliding and back doors and hood are closed and locked.
As the front doors are locked, the system will give you a preparation time of 30 seconds before the setting, during which the front, sliding and back doors and hood may be opened to prepare for the setting.
Be careful not to use the key when opening either front door. This will cancel the system.
4. After making sure the indicator light starts flashing, you may leave the vehicle.
The system will automatically be set after the preparation time elapses. The indicator light will flash to show the system is set. If any of the front, sliding and back doors and hood is opened at that time, the setting is interrupted until it is closed and locked.
Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate （使启动）the system.
WHEN THE SYSTEM IS SET
Activating the system
The system will give the alarm and cut the starter circuit under the following conditions:
If any of the front, sliding and back doors and hood is unlocked without using the key.
If the battery terminal is disconnected and then reconnected.
After one minute, the alarm will automatically stop with the starter circuit cut kept on.
Reactivating the alarm
Once set, the system automatically resets the alarm each time the front, sliding and back doors and hood are closed after the alarm stops.
The alarm will be activated again under the following conditions:
If any of the front, sliding and back doors and hood is opened.
If the battery terminal is disconnected and then reconnected.
Stopping the alarm
Turn the ignition key from the “LOCK”to “ACC”position. The alarm will be stopped with the starter circuit cut kept on. Stopping the alarm in this manner will keep the alarm from being reactivated when any of the front, sliding and back doors and hood is opened.
Interrupting the setting
With the system set, the back door can be opened with the key without activating or canceling the system. While it is open, the front and sliding doors and hood may be opened in addition, and the system can be activated only by the battery terminal disconnection.
To resume the setting, close and lock the front, sliding and back doors and hood. The back door must be closed with the key removed.
CANCELLING THE SYSTEM
Unlock either front door with the key, or unlock the sliding door with the key when it has been closed. This cancels the system completely and the starter circuit cut will be cancelled at once.
INDICATOR LIGHT
The indicator light gives the following three indications when the system is in use. When the light is:
FLASHING—The system is set. You need the key to open the front, sliding and back doors and hood.
ON—The system will automatically be set when the time comes. The front, sliding and back doors and hood may be opened without a key.
OFF—The system is inactive. You may open any door and hood.
TESTING THE SYSTEM
1. Open the drivers and front passengers windows.
2. Set the system as described above. The front doors should be locked with the key. Be sure to wait until the indicator light starts flashing.
，英语四级快速阅读专项练习（五）